INSUWRAP PVC 2500 TNL-FB

Apply (PVC 2500 TNL-FB) membranes loose laid for horizontal areas with 50mm overlap by using hot air welding technique. Horizontal PVC membranes shall be installed to 300mm height on the vertical walls to enable the welder to join the horizontal membranes at the corners properly with the followed vertical PVC membrane. Apply horizontally protection layer non-woven polyester (140g/m2) with 100mm overlap over the entire horizontal PVC membrane or as required. Cover sheets with permanent overlying construction as soon as possible. This can be done by applying a minimum 50mm thick concrete protection layer. Lay steel reinforcement and concrete as specified.

Apply (PVC 2500 TNL-FB) membrane vertically by mechanical fixing using PVC coated galvanized metal strips (50mm width) fixed horizontally to the walls by fasteners and receiving PVC membrane by using hot air welding technique over the strips. PVC rolls should be joined vertically with 50mm overlaps using hot air welding technique. For pipes, ducts, cables, and other penetrations through the sheets, ensure complete watertightness by using pre-formed collars fully bonded/sealed to both pipes and sheets. Dressing can be made at site using the same PVC liner. Cover external walls of tanking system with at-least (10mm thick) fiberboards. Provide a temporary support or contact adhesive to ensure full contact of boards to tanking system during back filling operation.